Step 6: attach paper bag, Step 4: attach bag compartment – Hoover Limited User Manual
Page 5
8
TABS
18
To replace bag door, insert the
2 tabs on bottom of bag door
into the 2 slots on bag compart-
ment. (Fig. 18)
15
HOOKS
DIRT
TUBE
SLOTS
BAG
COMPART-
MENT
Push paper bag collar firmly
onto tube. (Fig. 17)
17
16
BAG
COLLAR
DIRT
TUBE
Tuck top and bottom of paper
bag into bag compartment.
Align opening in paper bag with
dirt tube insidebag compart-
ment. (Fig. 16)
STEP 6: Attach
paper bag
Note round opening and hooks
on back of bag compartment.
Place opening over dirt tube
and align hooks with slots in
handle.
Push very firmly to snap
hooks into handle.
(Fig. 15)
Pull on bag compartment to
make sure it is completely
snapped to handle.
Make sure all edges of paper
bag are completely inside the
bag compartment.
Close door.
Continued
➜
TAB
Slide large tab on bottom of bag
housing into slot between the
bracket and the lower handle
(Fig. 14).
7
11
BOLT
NUT
If bolt will not go through hole
easily , check the following:
Push
bolt
into hole on lower
front of handle.
(Fig. 11)
• the bracket is properly
positioned (see Fig. 9)
• the handle is pushed
down completely
(see Fig. 10)
13
Pull bag door latch forward and
remove door. Set bag door
aside. (Fig. 13)
STEP 4: Attach
bag compartment
BAG DOOR
BAG DOOR
LATCH
12
NUT
Place
nut
in recessed area at
back of handle.
Hold nut in
place while tightening bolt
securely with a screw driver.
(Fig. 12)
Only one nut is needed on this
model. The extra nut is not
required but has been provided
for your convenience.
BRACKET
14