Hoover Limited - Manual (Page 12)

21
How to replace
Disconnect cleaner from electri-
cal outlet and detach hose from
cleaner.
1. Place handle in operating
position and turn cleaner over.
To remove bottom plate, insert
end of flat screwdriver into wide
area of right-hand slot and push
handle of screwdriver to the rear.
Repeat in left-hand slot.
2. Rotate plate and remove from
cleaner body.
3. Remove hood as directed in
steps 1-4 of "How to Replace
Headlight."
4. Remove agitator and broken belt.
SLOT SLOT
LIFT
HERE
22
BELT
GUIDE
7. Turn cleaner over and stretch
new belt onto motor pulley.
5. Slip agitator through new belt
(with lettering toward outside of
cleaner).
Lower end of belt into
opening in cleaner body; reposition
agitator.
6. Place the three tabs on bottom
plate into slots in front of cleaner
body. Snap bottom plate into place
over agitator.
8. Replace hood and nozzle control
knob.
Turn agitator, making sure belt is
not pinched between agitator and
cleaner body. The belt must rotate
freely inside the belt guide. If
agitator does not turn, remove
bottom plate and reposition belt in
belt guide.
Extra effort may be required to
stretch belt onto pulley.