Hitachi UT42V702 - Manual (Page 22)

21
CONNECTION (continued)
3. Attach Cushion, Secure with Clamps and Fit Terminal Cover (continued)
4. Connect the Power Plug into the Wall Socket
Connect the power cord after completing all other connections.
(For some countries the type of plug is different that depicted.)
3
Secure the HDMI cable and power cord with clamps.
4
Fit the terminal cover onto the monitor.
Insert the tabs into the slots as shown and fold downward
to fit the terminal cover.
CAUTION
Use only the power cord provided.
Do not use a power supply voltage other than that indicated (AC120, 60Hz). It may cause fire or electric shock.
For the LCD monitor, a three-core power cord with a ground terminal is used for efficiency protection. Always be sure
to connect the power cord to a three-pin grounded outlet and make sure that the cord is properly grounded. If you use
a power source converter plug, use an outlet with a ground terminal and screw down the ground line.
Ensure that both ends of the power cord are easily accessible.
If you have to change the power cord, please use a certified power cord that meets your region’s safety standards.
Tabs
Terminal Cover
Clamp
How to remove the cover.
Using your fingers, pull backwards to
lift the cover.
AC
Wall
Socket
Monitor
Rear
Panel
*This drawing shows UT37V702