HP 400 - Manual (Page 44)

Installation and Configuration 2-9
Localizing Factory Defaults
You can also use the DJPMenu configuration utility to change the factory default settings to those
appropriate to a particular country . Then when you reset the printer to the factory defaults, you will be
setting them to the “country defaults” that you changed with the DJPMenu configuration utility.
Changing a country default will cause the printer — after you have reset it — to use the default character
set and media size setting appropriate for that country. See table 2-3.
In order for the country default settings, that you have changed with DJPMenu, to actually take effect,
you must reset the printer.
Caution Once you have localized the factory default settings, you cannot restore the printer
to the original factory default settings. If you wish to restore the original factory
default settings, use DJPMenu to select “US” from the list of countries in the
Country Default group box.
Table 2-3. Country Defaults Available in DJPMenu
Country Default Media Size Character Set
US Letter PC-8 USA
UK A4 UK
Germany A4 Germany
France A4 France
Italy A4 Italy
Norway A4 Norway
Sweden A4 Sweden Names
Spain A4 Spain
Portugal A4 Portugal
Note Hewlett-Packard recommends that you do not change the factory default settings unless you have a
specific need for localized country default settings. Note that, even without changing the factory
default settings, you can make changes to the printer settings in Menu mode that will be retained
even after the printer is turned off and on any number of times.