Hitachi UT32A302 - Manual (Page 13)

12
ENGLISH
Remove the Stand Base from the Monitor
Install the Monitor on the Floor Stand
Attach the Monitor to the Floor Stand with the 4 screws used with the
tabletop stand.
3
CAUTION
UT32A302 and UT32A302W LCD UT Monitors are only for use with the Hitachi AS-LSZ0081 and
AS-LSZ0082 Floor stands respectively. Use with other floor stands could cause instability and
possible injury.
1
SAFETY PRECAUTIONS (continued)
Floor Stand Setup
2
Remove the 4 screws and raise straight up from tabletop stand.
CAUTION
Keep the screws. They will
be used for the Floor stand
installation.
Monitor
About the Installation
This product is heavy and should be carried
by at least 2 people.
For Stand Assembly; please refer to the Installation Manual of the Floor Stand AS-LSZ0081 or AS-LSZ0082.
Screws from the
tabletop stand.
Please make sure screws
are tightened properly.
CAUTION
Adjust Monitor position left or
right to match with screw holes.
If the screw holes do not align,
the Monitor may be damaged.
WARNING