Harbor Freight Tools 7" Variable Speed Polisher/Sander 69474 - Manual (Page 15)

Page 15 For technical questions, please call 1-800-444-3353. Item 69474
Sanding
1. Make sure that the surface to be sanded is wiped
clean of all dirt and debris, especially that of
previous courser sanding sessions, which will
scratch the surface of a finer grit sanding session.
2. Attach the desired grit Sanding Disk (sold
separately) onto the Backing Pad.
3. Rotate the Speed Dial to select
the desired speed setting.
4. Plug the Power Cord of the Polisher/Sander
into a grounded 120 volt, electrical outlet.
5. To start, grip the Polisher/Sander firmly with
both hands and press in on the Safety Lock
then the Trigger. Release the Safety Lock
and continue to hold in the Trigger.
6. Wait until the Polisher/Sander has reached
full speed, then gently contact the surface.
7. Keep heavy pressure off of the Polisher/Sander when
operating. Allow the sanding disk to do the work.
8. Move the Polisher/Sander in a uniform
pattern up and down or side to side as
you sand to ensure even sanding.
9. Periodically, stop the Polisher/Sander and
check for possible disc wear. Replace used
or worn sanding discs when necessary.
10. When finished, release the Trigger
and unplug the Power Cord.
11. Allow the tool to come to a complete
stop before setting it down.
12. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup