Harbor Freight Tools 7" Variable Speed Polisher/Sander 69474 - Manual (Page 13)

Page 13 For technical questions, please call 1-800-444-3353. Item 69474
Operating instructions
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tool Set up
tO pRevent SeRiOuS injuRY FROm aCCiDental OpeRatiOn:
Release the trigger and unplug the tool from its electrical outlet before installing accessories.
installing the Backing pad/Foam pad
1. The accessory MUST be:
• rated to at least 3377 RPM.
• no larger than 7″ (178 mm) in diameter.
• fitted with a threaded opening of 5/8″ x 11 TPI.
• undamaged.
• a backing pad.
2. Press in and hold the Spindle Lock Button
to prevent the Spindle from turning.
3. Thread the Backing Pad onto the Spindle
until firmly secured in place.
Workpiece and Work area Set up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup