Harbor Freight Tools 7" Variable Speed Polisher/Sander 69474 - Manual (Page 10)

Page 10 For technical questions, please call 1-800-444-3353. Item 69474
Specifications
Electrical Rating 120V~ / 60Hz / 10A
Motor No Load Speed 600-3500 RPM
Max. Accessory Diameter 7″ (178 mm)
Spindle Thread 5/8″ x 11 TPI
Accessories
(sold separately)
Backing Pad
Foam Pad
Polishing Bonnet
Sanding Discs
Setup - Before use:
Read the entiRe impORtant SaFetY inFORmatiOn section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
tO pRevent SeRiOuS injuRY FROm aCCiDental OpeRatiOn:
Release the trigger and unplug the tool from its electrical outlet before
assembling or making any adjustments to the tool.
note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
aSSemBlY
installing the auxiliary handles
tO pRevent SeRiOuS injuRY:
Do not operate this tool with one hand only or without the auxiliary handle(s) properly installed.
Figure a: handle installation Options
This Polisher/Sander includes two types of auxiliary handles. The D-Handle may be installed
for either right-hand or left-hand use. The Side Handle can be installed in one of three
positions on the head of the Polisher/Sander or together with the D-Handle.
Sa
Fet
Y
Ope
R
ati
O
n
m
aintenan
C
e
Setup