beautypg.com

Replacing switch and/or head tube, 7. replacing switch and/or head tube – Hobart Welding Products HANDLER OM-925 217 694A User Manual

Page 31

background image

OM-925 Page 27

Return To Table Of Contents

6-7. Replacing Switch And/Or Head Tube

Ref. ST-800 795-C

Tools Needed:

19 mm

Remove handle
locking nut.

Slide handle.

Secure head
tube in vice.

Loosen jam nut.
Remove from vice
and turn head tube
out by hand.

Hand-tighten head tube into cable connector.

Place head tube in vice and tighten until
nuts are tight.

Remove from vice. Reposition handle and install
switch housing. Secure with handle locking nut.

Y

Turn Off welding power source
/wire feeder and disconnect gun.

Remove switch housing. Install new switch and
connect leads (polarity is not important).
Reassemble in reverse order. If replacing head
tube, continue to end of figure.

1

3

2

4

5

8

6

7