Hobart Welding Products HANDLER OM-925 217 694A - Manual (Page 23)

OM-925 Page 19 Return To Table Of Contents
SECTION 5 − OPERATION
5-1. Controls
1 Wire Speed Control
Use control to select a wire feed speed. As
Voltage switch setting increases, wire
speed range also increases (see weld
setting label in welding power source or
Sections 5-2 or 5-3, as applicable).
2 Power Switch
3 Voltage Switch
The higher the selected number, the
thicker the material that can be welded
(see weld setting label in welding power
source or Sections 5-2 and 5-3, as
applicable). Do not switch under load.
.
Switch must “click” into detent position
1, 2, 3, 4, or purge for proper contact.
4 Voltage Switch - “Purge” Position
In purge position, fan runs but there is no
weld output or wire feed. Use “PURGE”
setting when adjusting gas flow at the
regulator.
Ref. 217 617-A
2
3 4
W I R E F E E D
V O L T A G E
P O W E R
O F F
O N
P U R G E 1
4 3
2
DO NOT SWITCH
WHILE WELDING
V
1