HP Paslode 403606-10 - Manual (Page 11)

2000 Series Stapler
Step No. 1 – Grasp the stapler firmly with one hand.
Depending on the model,either squeeze the latch
with your small finger or press it with your thumb
With your other hand, pull the magazine back
towards you.
Step No. 2 – Insert the fastener strip into the
magazine rail.
Step No. 3 – Push the magazine firmly towards the
front of the tool until it locks in place. The tool is now
ready for use.
6000 Series Strip Nailer
Step No. 1 – Grasp the nailer handle firmly. Pull the
magazine follower all the way to the rear of the
magazine and pivot it downward until it latches into
the locked position.
Step No. 2 – Insert the a strip of fasteners into the
top of the magazine with the point of the nails facing
the nose area.
Step No. 3 – Pivot the follower upward until it
releases then slide the follower forward until it
contacts the fasteners. The tool is now ready for
use.
11