Top panel, Setting up the dolphin multicharger, Supplying power to the dolphin multicharger – Hand Held Products Dolphin 7200 User Manual
Page 80: Supplying power to the dolphin multicharger -2
11 - 2
Top Panel
This section contains information regarding features located on the top panel of the Dolphin MultiCharger.
Setting Up the Dolphin MultiCharger
The Dolphin MultiCharger should be setup on any dry, stable surface.
You must connect the Dolphin MultiCharger to a power source for any type of operation.
Hand Held Products recommends that you leave the Dolphin MultiCharger connected to its power source at all times, so that it
is always ready to use.
Supplying Power to the Dolphin MultiCharger
Locate the AC power cord that came with your Dolphin MultiCharger. Plug the power cord into the Dolphin MultiCharger Universal
wide input voltage AC input, then plug the power cord into a wall socket.
Using a non-Hand Held Products power cord will void your warranty and can result in serious damage to the Dolphin
MultiCharger circuitry.
(see page 11-2) located in the bottom left-hand corner of the top panel. The
2) lights green and the unit performs a self diagnostic test.
Power Switch
Power
LED
Charging
Status
LEDs
Battery
Charging
Pocket
Condition and
Calibrate LED
Condition and
Calibrate Switch
!