Harbor Freight Tools CENTRAL PNEUMATIC 92841 - Manual (Page 11)

NOTICE
Clean the Spray Gun IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Spray Gun.
Page 11 For technical questions, please call 1-800-444-3353. Item 92841
SAFETY
Op
ERA
TION
M
AINTENANCE
SETU
p
Spray Gun Setup Adjustment
TO pREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained
within this manual. Improper adjustment can result in tool failure or other serious hazards.
CAUTION! Keep hands away from Trigger while making adjustments.
Note: This Spray Gun is meant
for spraying latex, stains and varnish.
paint preparation and Filling
Note: Proper paint mixture is essential.
Follow the manufacturer’s directions. Most paints
will spray easily if they are thinned properly.
1. Thin the paint according to manufacturer’s
directions and mix thoroughly.
2. Carefully strain the paint through
a paint strainer or a piece of cheesecloth.
3. Fill the Cup to no more than 2/3 full. Thread
the Paint Cup into the Gun Body and
tighten until the Cup is securely in place.
4. Start the air compressor and set
the regulator to needed pressure.
Do not exceed maximum air pressure.
5. Test the consistency by spraying
on a piece of scrap material.
If it appears too thick, add a very
small amount of thinner (not included)
and mix thoroughly. Use the proper
thinner for the type of paint. Thin
CAUTIOUSLY. Proceed slowly,
adding minimal amounts at a time.
DO NOT exceed the manufacturer’s
thinning recommendations.
Fan Direction
1.
Figure D: Fan Direction
Horizontal Fan
Vertical
Fan
Nozzle
Lock Ring
To change the direction of the
fan from horizontal to vertical,
loosen the Lock Ring and turn the Nozzle 90°.
2. After the adjustment, tighten
the Lock Ring by hand.