Harbor Freight Tools Central Machinery 6" Belt & 9" Sander 6852 - Manual (Page 7)

SKU 06852 For technical questions, please call 1-800-444-3353. PAGE 7
To Assemble The Stands, Frames, And Upper Bracket:
1. With assistance, position the two Stands (56) upright on the floor and parallel to
one another.
(See Figure C.)
2. Place the end of one Frame (64) on the inside edge of one Stand (56), and align
the two mounting holes on the end of the Frame with the two lower mounting
holes on the Stand.
(See Figure C.)
3. Secure the Frame (64) to the Stand (56), using two Bolts (58), two Washers (60),
and two Nuts (63).
(See Figure C.)
4. Repeat Steps #1, #2, and #3 to connect the other end of the Frame to the re-
maining Stand.
(See Figure C.)
5. To connect the remaining Frame (64) to the two Stands (56), follow Steps #1, #2,
#3, and #4).
(See Figure C.)
6. Place both Upper Brackets (57) on the top edges of the two Stands (56), and
align the eight mounting holes (two on each end) of the Brackets with the eight
mounting holes (two on each end) of the Stands.
(See Figure C.)
7. Secure both Upper Brackets (57) to the two Stands (56), using eight Bolts (58),
Washers (60), and Nuts (63).
(See Figure C.)
ASSEMBLY INSTRUCTIONS
NOTE: For additional references to the parts listed below, refer to the Assembly
Diagram on page 17.
STAND
(56)
STAND
(56)
FRAME
(64)
FRAME
(64)
BOLT (58)
WAShER (60)
NUT (63)
BOLT (58)
WAShER (60)
NUT (63)
UPPER BRACKET (57)
FIGURE C
UPPER
BRACKET
(57)
(mostly hid-
den)
REV 05b