Harbor Freight Tools Central Machinery 6" Belt & 9" Sander 6852 - Manual (Page 2)

SKU 06852 For technical questions, please call 1-800-444-3353. PAGE 2
PRODUCT SPECIFICATIONS
SAVE ThIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, op-
erating, inspection, maintenance and cleaning procedures, parts list and assem-
bly diagram. Keep your invoice with this manual. Write the invoice number on the
inside of the front cover. Keep this manual and invoice in a safe and dry place for
future reference.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
1. KEEP WORK AREA CLEAN AND DRY. Cluttered, damp, or wet work areas
invite injuries.
2. KEEP ChILDREN AWAY FROM WORK AREA. Do not allow children to handle
this product.
3. STORE IDLE EQUIPMENT. When not in use, tools and equipment should be
stored in a dry location to inhibit rust. Always lock up tools and equipment, and
keep out of reach of children.
4. DO NOT USE ThIS PRODUCT IF UNDER ThE INFLUENCE OF ALCOhOL OR
DRUGS. Read warning labels on prescriptions to determine if your judgement or
reflexes are impaired while taking drugs. If there is any doubt, do not attempt to
use this product.
REV 07g
Electrical Requirements 1 HP, Ball Bearing Motor
110 Volt/60 Hz/12.8 Amps
3450 Rpm
Overall Height 40”
Table Surface Dimensions 6-1/2” x 12-3/4”
Table Tilt 0-50 Degrees
Work Table Options For Sanding Disc or Sanding Belt
Use
Belt Size 6” x 48”
Disc Size 9” Diameter, PSA Type
Belt Speed 1280 FPM
Disk Speed 1720 RPM
Weight 121 lb.