Harbor Freight Tools Central Machinery 6" Belt & 9" Sander 6852 User Manual

Page 4

SKU 06852

For technical questions, please call 1-800-444-3353.

PAGE 4

SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS

MAINTAIN A SAFE WORKING ENVIRONMENT. Keep the work area well lit.
Make sure there is adequate surrounding workspace. Always keep the work area
free of obstructions, sawdust, grease, oil, trash, and other debris. Do not use the
Belt/Disc Sander in areas near flammable chemicals, dusts, and vapors. Do not
use the Belt/Disc Sander in a damp or wet location.

GROUND ThIS PRODUCT. The electrical Power Cord (55) for this product is
equipped with a grounded, 3-Prong Plug. Never remove the grounding prong or
modify the Plug in any way. Do not use adapter plugs with this product. To com-
ply with the National Electric Code, and to provide additional protection from the
risk of electrical shock, this product should only be connected to a 110 Volt,

3-hole electrical outlet that is protected by a Ground Fault Circuit Interrupter
(GFCI).

DO NOT ABUSE ThE POWER CORD. Do not use the Power Cord (55) to pull
its 3-Prong Plug from an electrical power outlet. Keep the Power Cord away from
heat, oil, sharp edges, and moving parts. Route the Power Cord safely. Do not
route the Power Cord where it can be walked on or tripped over. Replace a dam-
aged Power Cord immediately.

IF AN EXTENSION CORD (not included) IS USED, MAKE SURE TO USE
ONLY UL APPROVED CORDS hAVING ThE CORRECT GAUGE AND
LENGTh. This product requires a 14 gauge extension cord.

REDUCE ThE RISK OF ACCIDENTAL STARTING. Make sure the Power Switch
(53) is in the “OFF” position before plugging the Power Cord (55) into a grounded,
3-hole, 110 Volt, electrical outlet.

(See Figure B, and Assy. Diagram.)

PRIOR TO STARTING ThE BELT/DISC SANDER, MAKE SURE ALL ADJUST-
ING KEYS AND WRENChES ARE REMOVED FROM ThE TOOL.

BEFORE SANDING, TURN ON ThE BELT/DISC SANDER AND ChECK FOR
EXCESSIVELY LOOSE SANDING BELT/DISC (2, 15) OR MAChINE VIBRA-
TION. If this is found, turn off the tool and correct the problem before using.

ALWAYS KEEP hANDS AND FINGERS AS FAR AWAY AS POSSIBLE FROM
ThE MOVING PARTS OF ThE BELT/DISC SANDER.