beautypg.com

Installation instructions, Installation, Instructions – Hotpoint VBXR1060 User Manual

Page 18: Gas downdraft cooktop, Important safety instructions, For your safety, Before you begin, Important, Warning

background image

IMPORTANT SAFETY
INSTRUCTIONS

The cooktop has been design-certified by CSA
International. As with any appliance using gas and
generating heat, there are certain safety precautions
you should follow. You’ll find these precautions in the
Important Safety Instuctions section in the front of this
Owner’s Manual. Read them carefully.

Be sure your cooktop is installed properly by a qualified

installer or service technician.

The cooktop must be electrically grounded in accordance

with local codes, or in their absence, with the National
Electrical Code ANSI/NFPA No. 70—Latest Edition.

Installation of this cooktop must conform with local codes,

or in the absence of local codes, with the National Fuel Gas
Code ANSI Z223.1/NFPA 54—Latest Edition.

Improper installation, adjustment, alteration, service

or maintenance can cause injury or property damage.
Refer to this manual. For assistance or additional
information, consult a qualified installer, service agency,
manufacturer (dealer) or the gas supplier.

Disconnect electrical supply before servicing.

Never reuse old flexible connectors. The use of old flexible

connectors can cause gas leaks and personal injury.
Always use NEW flexible connectors when installing
a gas appliance.

Make sure the wall coverings around the cooktop can

withstand heat generated by the cooktop up to 200°F.

Avoid placing cabinets above the cooktop.

If cabinets are placed above the cooktop, allow a minimum

clearance of 30

between the cooking surface and

the bottom of protected cabinets.

A non-combustible material must be installed on

the under side of the cabinet. Use a flame retardant
millboard at least 1/4

(6.3 mm) thick, or gypsum board

at least 3/16

(4.7 mm) thick, covered with 28 gauge sheet

steel or 0.020

(.5 mm) thick copper. The maximum depth

of cabinets above the cooktop is 13

(33 cm).

FOR YOUR SAFETY

If You Smell Gas:

1. Open windows.
2. Don’t touch any electrical switches.
3. Extinguish any open flame.
4. Immediately call your gas supplier.
Do not store or use gasoline or other flammable vapors
and liquids in the vicinity of this or any other appliance.

Installation

Gas Downdraft Cooktop

Instructions

If you have questions, call 800.GE.CARES (800.432.2737)

or visit our Website at:

ge.com

BEFORE YOU BEGIN

Read these instructions completely and carefully.

IMPORTANT –

Save these instructions

for local inspector’s use.

IMPORTANT –

Observe all governing

codes and ordinances.

Note to Installer –

Be sure to leave these

instructions with the Consumer.

Note to Consumer –

Keep these instructions

for future reference.

Proper installation is the responsibility of the installer.
Product failure due to improper installation is not

covered under the Warranty.

WARNING –

Before beginning

the installation, switch power off at the service panel
and lock the service disconnecting means to prevent
power from being switched on accidentally. When
the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such
as a tag, to the service panel.

In the Commonwealth of Massachusetts:

This product must be installed by a licensed plumber

or gas fitter.

When using ball-type gas shut-off valves, they shall be

the T-handle type.

A flexible gas connector, when used, must not exceed

3 feet.

18