Control knobs and control panel seal, Grease jar, Porcelain cooktop – Hotpoint VBXR1060 User Manual
Page 15: Stainless steel surfaces, Control knobs and control panel seal grease jar, Care and cleaning of the cooktop
Control Knobs and Control Panel Seal
After grilling there may be soot on
the knobs and control panel seal. This
soot can be removed by scrubbing with
a plastic scrubber and mild dishwashing
detergent. The control knobs may
be removed for cleaning.
To remove a knob, pull it straight up.
Wash the knobs in soap and water but
do not soak. Avoid getting water down
into the knob stem holes.
Wipe with a sponge, damp cloth or
paper towel. Do not scrub with steel
wool pads or abrasive cleansers.
To replace a knob, match the flat part
of the knob opening with the flat side
of the shaft.
Care and cleaning of the cooktop.
ge.com
Before Cleaning
Before cleaning any part of your
cooktop, be sure all controls are off and
DISCONNECT ELECTRICAL POWER TO
THE COOKTOP at the fuse box or circuit
breaker panel, or pull the cooktop power
plug, located beneath the cooktop and
inside the cabinets.
Do not operate the cooktop without all
parts in place.
Grease Jar
A grease jar is located below
the grill basin pan under the countertop.
Check periodically to prevent spillovers.
Unscrew and remove.
If the jar is broken, replace with any
heat tempered jar, such as a canning jar,
that has a wide mouth screw neck.
Porcelain Cooktop
The porcelain enamel finish is sturdy
but breakable if misused. This finish
is acid-resistant. However, any acidic
foods spilled (such as fruit juices, tomato
or vinegar) should not be permitted
to remain on the finish.
If acids spill on the cooktop while it
is hot, use a dry paper towel to wipe it
up right away. When the surface has
cooled, wash with soap and water or
cleansing powders. Rinse well.
For other spills, such as fat spatterings,
wash with soap and water or cleansing
powders after the surface has cooled.
Rinse well. Polish with a dry cloth.
Stainless Steel Surfaces
Do not use a steel wool pad;
it will scratch the surface.
To clean the stainless steel surface,
use warm sudsy water or a stainless
steel cleaner or polish. Always wipe
the surface in the direction of the grain.
Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless
steel appliance cleaner or polish, or to
find the location of a dealer nearest you,
please call our toll-free number:
National Parts Center
800.626.2002
ge.com
Safety Instructions
Operating Instructions
Car
e and Cleaning
Tr
oubleshooting Tips
Consumer S
uppor
t
15