Harley-Davidson 74230 - Manual (Page 12)

• Place a cap nut on a flat surface, inside up.
• Fit the end of the front axle into the cap nut.
• Tap the opposite side of the front axle with a hammer to
secure the cap nut to the front axle. Pull on the cap nut to
be sure it is secure.
• Before applying the labels to the wheel, wipe the wheel
with a clean, dry cloth to make sure it is free of dirt and
oils. Make sure your hands are clean.
• Apply the labels to both sides of the wheel as shown in
the illustration.
• Position the vehicle upside down.
• Note the arrow on the underside of the front fender.
• Position the front fender so that the arrow points toward
the front of the vehicle. Slide the front fender completely
onto the ends of the handlebars.
• Fit an inner shock to the inside of the handlebar.
• Fit an outer shock to the outside of a handlebar.
• Slide the shocks down into the front fender.
• Repeat this procedure to assemble the shocks to the
other handlebar.
Assembly
12
16
13
14
15
Arrow
Front Fender
Handlebar Handlebar
Front
Fender
Handlebar
Outer
Shock
Inner Shock
Cap Nut
Front Axle
1
2
Wheel