HP ep7100 - Manual (Page 47)

User’s Guide 47
5
Installing permanently
Installing the projector
Installing on a table
This installation is covered in detail in Chapter 1. See “Setting up the projector”
on page 15 for more information.
Installing on the ceiling
Å WARNING: To minimize the risk of injury from improperly installed
equipment, it is recommended that a professional installer performs the ceiling
installation.
1. Attach the projector to the ceiling using an HP L1733A ceiling mount kit.
The base of the projector must by removed when it is attached to the ceiling
mount. See the installation instructions provided with the ceiling mount kit.
2. After the projector is mounted on the ceiling, adjust the projector settings to
match this setup. Press menu, select Setup > Projector position, and select
Front Ceiling from the drop-down list.
Installing for rear projection
1. Place the projector 1 to 10 m (3 to 33 ft) behind a translucent screen that is
designed for rear projection.
See “Setting up the projector” on page 15 or “Installing on the ceiling” on
page 47 for more instructions.
2. Press menu and select Setup > Projector position. Then select Rear Table
or Rear Ceiling.