Healthrider HRSY23080 - Manual (Page 8)

8
12. Attach the upper ends of the Weight Guides (15) to
the welded bracket underneath the Weight Upright (2)
with two 3/8Ó x 1 3/4Ó Bolts (57) and two 3/8Ó Nylon
Locknuts (50). Tighten, but do not overtighten, the
Nylon Locknuts.
12
11. Slide a 3/8Ó Flat Washer (55) and a 5/8Ó x 1/2Ó
Bushing (85) onto a 3/8Ó x 2 3/4Ó Bolt (47). Line up
the hole in the indicated Weight Guide (15) with the
hole in the Weight Base (5). Slide the 3/8Ó x 2 3/4Ó
Bolt through the Weight Guide and the Weight Base.
Slide a 5/8Ó x 1/2Ó Bushing (85) onto the Bolt. Secure
the Bolt with a 3/8Ó Flat Washer (55) and a 3/8Ó Nylon
Locknut (50).
11
85
85
47
5
55
55
15
57
50
2
50
15
10. Attach two Bumpers (40) to the Weight Base (5) with
two #8 x 1Ó Screws (78). Insert the two Weight Guides
(15) through the indicated holes in the Weight Base
(5).
See the inset drawing. Press two Weight Inserts (77)
into the indicated holes in each Weight (21). Make
sure the large pin groove is pointed downward, as
shown. Slide all of the included Weights (21) onto
the two Weight Guides (15). Make sure the Weights
are oriented correctly. The adjustment holes must
be turned towards the center of the unit, as
shown.
For packaging purposes, the Top Weight (16) is
mounted in the upper threaded hole in the Weight
Tube (17). Unless you have bought the Weight
Expansion Set with five extra weight plates along with
your system, the Top Weight must be moved. Use the
Allen Wrench (100) to loosen the Button Head Screw
(52) and slide the Top Weight down to the lower of
the two threaded holes in the Weight Tube, as
shown. Lubricate the insides of the holes in the Top
Weight (16). Press the Weight Tube Bumper (18) into
the indicated end of the Weight Tube (17). Slide the
Weight Tube (17) with the Top Weight (16) onto the
Weight Guides (15). Attach the Allen Wrench Holder
(79) to the indicated location on the Seat Frame (7)
Locate the decal sheet with the stickers showing the
numbers 1 through 15. Place a sticker on each
Weight (21) and the Top Weight (16) right next to the
adjustment holes (see the inset drawing). The Top
Weight must have the number 1 on it.
10
5
15
16
52
17
18
100
7
79
2
78
40
21
77
21
Large Pin
Groove
Number
Decal
Adjustment
Holes on this
side
Place Stickers
on this side
Lubricate
Welded
Bracket