Dial cycles, Dial cycles , 11, About the dial cycles – Hotpoint HDA100 User Manual
Page 10: Rinse & hold, Plate warmer, Start delay
Safety Infor
mation
Operating Instr
uctions
Tr
oubleshooting T
ips
Customer Ser
vice
About the dial cycles.
Rinse & Hold
(HDA150, HDA180, HDA200, HDA300, HDA330,
HDA900 and HDA930 only)
For rinsing partial loads that will be washed later.
Do not
use detergent.
Make sure
HEATED DRY OFF
is selected.
Be sure the door is unlatched.
Slowly turn the Dial to
RINSE & HOLD.
Latch the door to start the cycle.
4
3
2
1
OFF
ON
WATER
SAVER
RINSE & HOLD
PLATE
WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
Plate Warmer
(HDA200, HDA300, HDA330, HDA900 and
HDA930 only)
For warming clean dishes and serving plates. This cycle
will take approximately 32 minutes.
Load clean dishware to be warmed.
Select
HEATED DRY ON.
Be sure the door is unlatched.
Slowly turn the Dial to
PLATE WARMER.
Latch the door to start the cycle.
5
4
3
2
1
OFF
ON
WATER
SAVER
RINSE & HOLD
PLATE
WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
10
Start Delay
(HDA900 and HDA930 only)
The
START DELAY
will allow you to delay the start
time of any cycle not on the Dial automatically for up
to 6 hours.
Be sure the door is unlatched.
Select the wash cycle and Option you want.
Slowly turn the Dial to desired time. The
CYCLE ON
light will come on.
Latch the door to start the cycle.
4
3
2
1
START DELAY
OFF
RINSE & HOLD
PLATE
WARMER
(HEATED DRY OFF)
(HEATED DRY ON)
START
(HOURS)
6
4
2