Hotpoint HDA3600 User Manual
Wood insert cut-out dimensions (in inches), Ge/hotpoint/rca, Dishwasher dimensions (in inches)
This wall area
must be free of
pipes or wires
Countertop
4
6
Hot
water
line on
left
4
4
2
Plumbing and electrical
service must enter
inside shaded area
24" From wall
24" MIN.
90°
19" MIN. from wall
24"
MIN.
6
34" to 34-3/4"
Underside
of countertop
to floor
5
5
90°
Electrical
wiring on
right
Electrical
wiring is
3" from
cabinet
24
25-3/4
MAX.
21-1/2
3-1/4
4 (Adjustable)
34 MIN.
adj. to 35
24-3/4
23-3/8
Electrical Rating
Voltage AC............................................... 120
Hertz........................................................ 60
Total connected load amperage............. 8.6
Calrod
®
heater watts max................... 500
For use on adequately wired 120-volt, 15-amp circuit
having 2-wire service with a separate ground wire.
This appliance must be grounded for safe operation.
Note: Dishwasher must not be installed more than
10 feet from sink for proper drainage. All plumbing
and electrical work must be in accordance with
local codes. Dishwasher includes drain hose and
leveling legs.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
Dishwasher Dimensions (in inches)
As an EnErgy STAr
®
partner, gE has determined
that this product meets the
EnErgy STAr guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
HDA3600/3640N – Hotpoint Built-In Dishwasher
Specification Created 4/07
450152
C
B
Access insert
Panel Thickness
Door insert
Front
of
Panel
Dishwashers Installation
(Pub. 1-G003 pg. 131B) May 12, 1993
Wood Insert Cut-Out Dimensions (in inches)
GE/Hotpoint/RCA
A
1-1/2
1/2
When using GPF325
1/4" custom dishwasher
door and access panel kit.
When using GPF375
3/4" custom dishwasher
door and access panel kit.
1/4
3/4
Panel
Thickness
Kit
A
B
C
GPF325
18-7/8"
23-9/16"
3-11/16"
1/4"
GPF375
18-15/16"
23-5/8"*
4-1/4" to
3-3/4"**
3/4"
* Bottom of panel must be notched 1-1/2" x 1/2" to clear across panel
** Adjustment required to match adjacent cabinet fronts due
to leveling leg adjustment, 4" nominal