Support bel/can in ack/nak, Rs232 defaults, Ncr modifiers – Honeywell VOYAGER 1250G User Manual
Page 49: Ncr ack/nak, Support bel/can in ack/nak -25 rs232 defaults -25, Ncr modifiers -25, Ncr ack/nak -25

2 - 25
Support BEL/CAN in ACK/NAK
This protocol responds to
NAK mode. The scanner sounds an error tone when a
sent from the host.
Default = BEL/
CAN Off.
RS232 Defaults
If you want the custom RS232 default settings restored to your scanner,
scan the RS232 Defaults bar code below. This resets the scanner to the
custom default settings (see
there are no custom defaults, it will reset the scanner to the factory default
settings. Any settings that have not been specified through the custom
defaults will be restored to the factory default settings.
NCR Modifiers
NCR ACK/NAK
This is an NCR communication protocol for ACK/NAK processing.
Default
= NCR ACK/NAK Off.
BEL/CAN On
* BEL/CAN Off
RS232 Defaults
* NCR ACK/NAK Off
NCR ACK/NAK On