Harbor Freight Tools BELT SANDER - 1 X 30 INCHES 2485 - Manual (Page 9)

Page 9 SKU 02485 for technical questions, please call 1-800-444-3353.
AsseMbly
The Belt Sander requires minor assembly of the Table (29) to the Main Body (23). Refer
to the Parts List and Assembly Drawing at the end of this manual.
Cover Knob (16)
Tension Handle (37)
Back Pulley (14)
Sanding Belt
Tracking Knob (16)
Side Cover (10)
Remove Cover Knob (16) and take off the Side Cover (10). See illustration above.
Remove the Screw (9) and Toothed Washer (24) from the end of the Locking Stud
(25).
Place the Table (29) on the Main Body (23) so that the Sanding Belt (5) fits through
the Slot in the Table.
Attach the Table by placing the Handle Assembly on the Table side and securing the
entire assembly using Screw (9).
Replace the Side Cover.
Spark Shield (43) Spark Cover (43)
Screw (44)
Main Body (23)
Frame (23)
Screw (9)
(Under Table)
Sanding Belt (5)
Table Slot
Main Body (23)
Table Lock Handle Assembly (24-28)
Table (29)
Toothed Washer (24)
Loosen the Screw (44) most of the way as shown above.
1.
2.
3.
4.
5.
6.