Harbor Freight Tools BELT SANDER - 1 X 30 INCHES 2485 - Manual (Page 3)

Page 3 SKU 02485 for technical questions, please call 1-800-444-3353.
or modify the plug in any way. do not use any adapter plugs. check with a quali-
fied electrician if you are in doubt as to whether the outlet is properly grounded.
If the tools should electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user.
double insulated tools are equipped with a polarized plug (one blade is wider
than the other). this plug will fit in a polarized outlet only one way. if the plug
does not fit fully in the outlet, reverse the plug. if it still does not fit, contact a
qualified electrician to install a polarized outlet. do not change the plug in any
way. Double insulation eliminates the need for the three wire grounded power cord
and grounded power supply system.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and
refrigerators. There is an increased risk of electric shock if your body is grounded.
do not expose power tools to rain or wet conditions. Water entering a power tool
will increase the risk of electric shock.
do not abuse the power cord. never use the power cord to carry the tools or pull
the plug from an outlet. keep the power cord away from heat, oil, sharp edges,
or moving parts. replace damaged power cords immediately. Damaged Power
Cords increase the risk of electric shock.
when operating a power tool outside, use an outdoor extension cord marked
“w-A” or “w”. These extension cords are rated for outdoor use, and reduce the risk
of electric shock.
persOnAl sAfety
stay alert. watch what you are doing, and use common sense when operating a
power tool. do not use a power tool while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating power tools may
result in serious personal injury.
dress properly. do not wear loose clothing or jewelry. contain long hair. keep
your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or
long hair can be caught in moving parts.
Avoid accidental starting. be sure the power switch is off before plugging in.
Carrying power tools with your finger on the Power Switch, or plugging in power tools
with the Power Switch on, invites accidents.
remove adjusting keys or wrenches before turning the power tool on. A wrench
or a key that is left attached to a rotating part of the power tool may result in personal
injury.
do not overreach. keep proper footing and balance at all times. Proper footing
and balance enables better control of the power tool in unexpected situations.
use safety equipment. Always wear eye protection. Dust mask, nonskid safety
shoes, hard hat, or hearing protection must be used for appropriate conditions. Always
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.