Husqvarna 230 ACX - Manual (Page 21)

22 - English
3. INSTALLATION
Best position for the boundary wire
The boundary wire should be laid so it:
• Forms a loop around the working area for
Automower™. Only an original boundary wire
must be used. This is tinned and has a high quality
insulation to withstand the dampness in the
ground.
• Maintains a maximum distance of 100 ft
(35 metres) from Automower™ in the entire
working area.
• Ideally not longer than 1600 ft (500 metres).
• The boundary wire is laid at different distances
from obstacles depending on what the working
area borders. The picture below shows how the
boundary wire should be routed around the
working area and around obstacles.
Boundaries for the working area
If a high obstacle, for example a wall or fence,
borders the working area, the boundary wire should
be laid 14" (35 cm) from the obstacle. This will
prevent Automower™ from colliding with the obstacle
and reduce body wear.