Hayter Mowers Clipper 46 401R - Manual (Page 20)

WARNING - PREVENT ACCIDENTS : Before mowing,
thoroughly inspect the area where the mower is to be
used and remove all objects which when contacted by
the mower cutterbar could become dangerous projec-
tiles.
Inspect the area for hidden obstructions which when
contacted by the cutterbar could risk health and safety.
Remember the location of these obstructions and ensure
that you mow around them.
IMPORTANT- PREVENT ENGINE DAMAGE : DO
NOT use the mower on a slope greater than 20 degrees.
To adjust the height of cut: Adjust each wheel in turn.
Adjust each front wheel by first moving the lever outward
to “unlock” and then towards the rear of the mower to
increase (+) or towards the front of the mower to decrease
(-) the height of cut. Release the lever and ensure that it
locks firmly in position.
Repeat this procedure for the two rear wheels. To increase
(+) move the lever towards the front of the mower and to
decrease (-) move the lever towards the rear of the mower.
Finally check that the height of cut settings are the same for
all four wheels to ensure that the mower is level. There are
four height of cut positions
Always select a height of cut to suit operating conditions.
Aim to prevent engine overloading and blockages by avoid-
ing low cuts in long grass conditions. Be prepared to make
two cuts when the grass is long.
OPERATING THE MOWER
401001EB100398A
1.19 1.19
20omax.
ST008
SAFETY NOTICE
HEIGHT OF CUT
+
_
ST005
Front
CS031
+
_
ST006
Rear