Hitachi VTMX-231A - Manual (Page 35)

TIMER RECORDING
35
CHANNEL 16
REC SPEED - -
• Remember refer to "ANTENNA/CABLE CONNECTIONS" on pages 11 and 12 if you have a cable box or satellite
box before setting the channel number.
10 Set the tape speed
Press /PLAY or /STOP button repeatedly until your desired tape speed appears. (Example: SP)
ONE TIME PROGRAM
DATE 05 / 06 WED
START TIME 07 : 30 PM
END TIME 08 : 30 PM
CHANNEL 16
REC SPEED SP
→
SP LP
SLP
11 Finish setting the program
Press F.FWD/ button. Program 1 is now completed.
• To set another program, repeat steps [2] to [11].
• Press RESET/EXIT button to return to original mode.
12 Set the timer
Press POWER button. The "
þ" indicator appears on the VCR's digital display.
• Please see "HINTS FOR TIMER RECORDING" on page 24 for more information.
HINTS FOR TIMER RECORDING
• If there is a power failure or the VCR is unplugged for more than 30 seconds, the clock setting and all timer settings are
lost.
• If the tape runs out before the end time, the VCR will switch to the Stop mode immediately, eject the tape and the VCR
power will be turned off. The "
þ" indicator will flash.
• If a tape is not inserted or the erase-protection tab is removed, the "
þ" indicator flashes and timer recording cannot occur.
Please insert a recordable tape.
• The TV that is connected to your VCR may be turned ON or OFF when the VCR is in the timer-record mode.
CORRECTING AN AUTOMATIC TIMER PROGRAM
1) Turn the power on.
2) Repeat steps [1] to [3] on page 22.
3) Go to the digit you want to change using the F.FWD/ button or REW/ button.
4) Enter correct numbers using /PLAY or /STOP button.
4) Press RESET/EXIT button to return to original mode.
5) Press the POWER button to return to timer stand-by mode.
STOPPING A STARTED AN AUTOMATIC TIMER PROGRAM