Hampton Direct H15-LP1 - Manual (Page 35)

Hampton ® H15-1 Direct Vent Freestanding Gas Stove 35
WIRING DIAGRAMS
CAUTION: Label all wires prior
to disconnection when servicing
controls. Wiring errors can cause
improper and dangerous opera-
If any of the original wires as supplied with the
appliance must be replaced, it must be replaced
with CSA type SEW (200
o C) or its equivalent.
This heater does not require a 120V A.C. sup-
ply for operation. In case of a power failure, the
burner switch and the optional remote control/
thermostat will continue to operate. However,
a 120V A.C. power supply is needed for the
fan/blower operation.
Caution: Ensure that the wires do
not touch any hot surfaces and are
away from sharp edges.
WARNING: Electrical Grounding Instructions
This appliance is equipped with a three pronged (grounding) plug for your protection against shock hazard and should
be plugged directly into a properly grounded three-prong receptacle. Do not cut or remove the grounding prong from
this plug.
For NATURAL GAS Units and Units NOT Equipped with DC Spark Boxes
INSTALLATION