Hampton Direct H15-LP1 - Manual (Page 21)

Hampton ® H15-1 Direct Vent Freestanding Gas Stove 21
RESIDENTIAL AND MANUFACTURED HOMES / MOBILE HOMES
MINIMUM HORIZONTAL TERMINATION INSTALLATIONS
Planning Your Venting Installation
See the "Exterior Vent Terminal Locations"
section for requirements.
When planning your installation, it will be nec-
essary to select the proper length of vent pipe
for your particular requirements. Determine the
minimum clearance to combustibles from the
rear of the unit to the wall. It is also important to
note the wall thickness. Before cutting the vent
hole through the wall ensure that ALL vent and
termination clearances (Refer to the "Exterior
Vent Terminal Locations" section) will be met.
*If this is an outside corner, the minimum distance
between the vent and the outside corner is 6"
(15cm). See "F" on the diagram in the "Exterior
Vent Terminal Locations" section.
NOTE: Ensure compliance with the outside
vent terminal location before cutting hole as
both dimensions must be met.
Minimum components for a Horizontal Installation:
640-944
Horizontal Termination Kit which includes:
1 6-5/8" Dia. x 18" Black Pipe
1 4" Dia. x 18" Aluminum Vent
1 946-202 Wall Penetration Heat Shield (Wall Thimble) (2 pcs)
1 640-530/P Riser Vent Terminal
1 640-545/P Decorative Wall Trim (Black)
1 948-128 Tube Mill-Pac Screws
380-946 Horizontal Termination Kit which includes:
1 6-5/8" Dia. x 12" Black Pipe
1 4" Dia. x 12" Aluminum Vent
1 946-202 Wall Penetration Heat Shield (Wall Thimble) (2 pcs)
1 946-523/P AstroCap
1 640-545/P Decorative Wall Trim (Black)
1 948-128 Tube Mill-Pac Screws
Optional Components:
946-204
45 o Elbow - 6-5/8" Black pipe 946-523/P AstroCap
and 4" Aluminum Vent 946-206 Vinyl Siding Standoff (AstroCap)
946-205 Vinyl Siding Shield for Riser Vent 946-506/P Vent Guard (AstroCap)
Terminal
946-208/P Vent Guard (Riser Vent Terminal)
940 Square Wall Thimble Cover*
981 Snorkel Termination (36")*
982 Snorkel Termination (14")*
942 Wall Penetration
Heat Shield*
* Simpson Dura-Vent Components
You will require the following components with your new Hampton ® Direct Vent Freestanding Gas
Stove. Please review your product to make sure you have everything you need. In the event that
you are missing any part, contact your dealer. Decorative brass or chrome trim kits are available
from Simpson Dura-Vent for their wall thimbles, as well as a square wall thimble cover.
Note: These are the minimum pieces required. Other parts may be required for your par-
ticular installation.
Kit #640-944
Kit #380-946
INSTALLATION