Hampton Direct H15-LP1 - Manual (Page 29)

Hampton ® H15-1 Direct Vent Freestanding Gas Stove 29
THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER IF IN DOUBT DO NOT DO THIS CONVERSION !!
CONVERSION KIT# 381-969 FROM NG TO LP
Each Kit contains one LPG
Conversion Kit and one DC
Sparker Kit.
LPG Conversion Kit Contains:
Qty. Part #
Description
1 904-575 Burner Orifi ce #55
1 918-590 Label "Converted to
Propane"
1 908-528 Red "LPG" label
1 904-529 5/3" Allen Key
1 910-037 LP Injector (Pilot Orifi ce)
1 918-479 Instruction Sheet
DC Sparker Kit Contains:
Qty. Part #
Description
1 820-475 Bracket DC Sparker
1 820-476 Bracket DC Sparker
1 904-153 Washer #8 External Star
1 904-330 Nut 8-32 Hex
1 904-438 Plug Nylon 0.750 Hole,
Black
1 904-531 Bushing Split Plastic
0.500 in.
1 904-543 Screw 8-32 x 3/4 Pan
Head
2 904-553 Screw #8 x 1/2 Type "B",
Black Oxide
1 910-073 Spark Generator Battery
Holder
1 910-074 Spark Generator Switch
C/W Wire
1 910-078 Battery Size AA
Energizer En91
2 910-199 Clip Wire Holder
1 910-903 Wire Fan To Power Cord
Ground 30 in.
904-781 Velcro Hook, Black
904-782 Velcro Hook, Black
1) Shut off the gas supply.
2) Lift off Cast Top, remove Cast Front and
Glass Door (refer to the glass replace-
ment section in the manual) and carefully
remove logs and lava rock.
Pilot assembly
is now
accessible
for steps the
following
steps.
Screws
Note: Use a magnetic type screwdriver
if possible.
3) Remove burner by removing the 2 screws
on each side and then slide the burner to
the left and lift out.
Installation of LPG
Conversion Kit:
4) Turn control knob to the “OFF” position.
5) Remove the black protection cap by
hand from the high-low knob (Fig.1).
Fig. 1
6) Insert a 5/32” or
4mm Allen wrench
into the hexagonal
key-way of the
screw (Fig. 2),
rotate it counter-
clockwise until it is
free and extract it.
7) Check that the screw is clean and if
necessary remove dirt.
8) Flip the screw (Fig. 3).
Fig.2
Fig.3
9) Using the Allen wrench as shown in
Fig.4, rotate the screw clockwise until
snug, do not overtighten.
Fig.4
WARNING!
Do not overtighten the screw.
Recommended to
grip the wrench by the short side.
10) Verify that if the conversion is from
NG to LPG, the screw must be
reassembled with the red o-ring visible
(Fig. 5).
LPG Configuration
Red o-ring visible
Fig.5
INSTALLATION