Hearth and Home Technologies Castile Insert Pellet CASTINS-CWL - Manual (Page 2)

Page 2 250-7251F September 1, 2008
R Castile Pellet Insert
Hearth & Home Technologies welcomes you to our
tradition of excellence! In choosing a Quadra-Fire
appliance, you have our assurance of commitment
to quality, durability, and performance.
This commitment begins with our research of the
market, including ‘Voice of the Customer’ contacts,
ensuring we make products that will satisfy your
needs.
Our Research and Development facility then
employs the world’s most advanced technology
to achieve the optimum operation of our stoves,
inserts and fireplaces. And yet we are old-fash-
ioned when it comes to craftsmanship. Each unit
is meticulously fabricated and are hand-finished for
lasting beauty and enjoyment.
Our pledge to quality is completed as each model
undergoes a quality control inspection. From
design, to fabrication, to shipping: We wish you
and your family many years of enjoyment in the
warmth and comfort of your hearth appliance.
Thank you for choosing Quadra-Fire.
SAMPLE OF CLEARANCE TO COMBUSTIBLES LABEL
LOCATION: On beaded chain behind right access
panel. Panel hinges open.
Report No.
#061-S-42-2
7014-143
SAFETY LABEL
R
Castile Pellet Insert
Listed Solid Fuel Room Heater/Pellet Type Insert. Also suitable for Mobile Home Installation. This
appliance has been tested and listed for use in Manufactured Homes in accordance with OAR
814-23-9000 through 814-23-909.
Tested to: ASTM E-1509-95, ULC S628-93, ULC /ORD-C1482-M1990 Room Heating Pellet Burning Type,
(UM) 84-HUD FOR USE ONLY WITH PELLETIZED WOOD OR SHELLED FIELD CORN FUEL.
Route power cord away from unit. Do not route cord under or in front of appliance.
Input Rating: 30,000 BTU/HR.
Electrical Rating: 115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 AMPS.
MINIMUM CLEARANCES TO COMBUSTIBLE MATERIALS
AS A BUILT-IN UNIT
Masonry or Zero Clearance
DO NOT REMOVE THIS LABEL
A Insert side to combustible 0 in. 0mm
B Insert top to mantel 12 in. 305mm
C Insert top to face trim 0 in. 0mm
D Insert side face trim 0 in. 0mm
E Hearth extension from door opening 6 in. 152mm
F Hearth extension from side of door opening 6 in. 152mm
B
D C
C
A
B
E
0 in. Clearance To Exposed Section and Face Trim
A Top of Hopper Top/Rear Vent 0 in. (0mm)
B Side of Outside Skin Top/Rear Vent 0 in. (0mm)
C Back of Hopper
Rear Vent 0 in. (0mm)
Top Vent 2.5 in. (64mm)
D Vent Pipe to Combustible Rear Vent 3.0 in. (76mm)
E From Panel Edge
0 in. (0mm)
SIDE W
ALL
MANTEL
B
A
C
E
D
F
Face Trim
1445 Highway North, Colville, WA 99114
Manufactured by:
www.quadrafire.com
O-T L Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C US
SAMPLE
This model is exempt from EPA certification
under 40 CFR 60.531 by definition [Wood
Heater (A) "Air-to-Fuel Ratio"].
AN FEB MAR APR MAY UNE ULY AU SEPT OCT NOV DEC
0-7 F
CASTILE PELLET INSERT R SERIAL NO. / NUM RO DU S RIE
DO NOT REMOVE THIS LABEL Made in U.S.A.
Report / Rapport
#061-S-42-2
C T
TTE T
T E ER T T T C EE C RE C T F R T RE . C T CT C SE S
R S. SEE E TE STR CT S. perate t is nit it el opper lid closed. Fail re to do so ma
res lt in emissions prod cts com stion rom t e opper nder certain conditions. aintain opper seal in
ood condition. o not o er ill opper.
C RS E R T . E S T C ER. R E ES E F TS ET ES TE E TS E
ES CE S E ST T . E C T CT E T C SER ES R RES E . R
T ETTE ET ES STR CT S. p re cet appareil a ec le co ercle de la tr mie erm . e d a t de ne pas s i re les instr ctions
pe t r s lter so s certaines conditions en ne com stion des missions des prod its enant de la tr mie. e pas remplir la tr mie trop pleine.
007
00 00 010
U.S. ENVIRONMENTAL
PROTECTION A ENCY
NE PAS ENLEVER L TI UETTE Fait A tats-Unis
O-T L Tested and
Listed by
Portland
Oregon USA
OMNI-Test Laboratories, Inc.
C US
Test Lab &
Rpt Nbr.
Mfg Date Model
Name Serial No.
SAMPLE OF SERIAL NUMBER & DATE OF MANUFACTURE LABEL
LOCATION: Inside hopper on the top