Harbor Freight Tools 98089 - Manual (Page 12)

SKU 98089 For technical questions, please call 1-800-444-3353 PAGE 12
Once the proper fuel mix is obtained, remove the Fuel Tank Cap (16C). Fill the 3.
Fuel Tank (2C, 10C) approximately 3/4 full with the fuel mix (the Fuel Tank capacity
is 0.4 gallons). Then, replace the Fuel Tank Cap. (See Figure a.)
Fuel miX QuanTiTieS
Ratio Two Cycle Oil Unleaded Gasoline (91 Octane)
50:1 4 Fl. Oz. 1.5 Gal.
50:1 8 Fl. Oz. 3 Gal.
50:1 16 Fl. Oz. 6 Gal.
Table a
OPeRaTinG inSTRuCTiOnS
note: Please read and familiarize yourself with the How To Stop The Cut Off Saw
instructions on page 13 before operating.
To Start The Cut Off Saw:
WaRninG! 1. Wear ANSI-approved safety impact goggles, hearing protection, and
NIOSH-approved dust mask/respirator during use.
Place the Cut Off Saw on flat, level ground, so that the Saw Blade (not included)
2.
does not contact any objects or the ground. Orient the saw away from your body.
FiGuRe B
7B
3G
9D
10D
5C
5D
3. Move the ON/OFF Button (5D) to the on position. Place your hand on the Rear
Handle (7D). Hold the Trigger Safety Lever (16D) down with your palm while
squeezing the Trigger (10D) and then using your thumb, press down on the Full
Throttle Lock Button (9D). (See Figure B.)
3C
26D
BLADE NOT
INCLUDED
REV 08f