Holder C-Trac C 9700 - Manual (Page 178)

Operating Instructions
145 052 177
C 9700 ... C 9.88 H
Maintenance Every 500 Service Hours
Changing the Engine Oil
- Run the engine warm to operating temperature.
- Set the heating control to high.
- Place the tractor on level ground and turn off the
engine.
- Place a suitable oil pan underneath the engine.
CAUTION
Danger of scalding when draining hot engine
oil.
- Unscrew the oil drain plug.
- Allow the oil to run out completely.
ATTENTION
Observe the instructions for handling fuels
and lubricants.
- Screw the oil drain plug in again with a new seal and
tighten to a torque of 55 Nm.
- Fill new engine oil at the filler neck (1). Only use
recommended engine oil.
Filling quantity ....................... 8.75 litres (2.31 USGAL.)
- Let the engine idle shortly.
- After approx. 1 minute, check the oil level with the
dipstick (2).
Bild_189
1
2
Bild_188