Emerson Radio ES2 - Manual (Page 26)

25
4. Immediately press the B or F buttons to set the display to the desired
wake up hour. Example: 6:00 AM (Observe the AM/PM indicators to be sure you
are setting the hour correctly.)
5. Immediately press the MEMORY (PROG)/CLOCK ADJ button. The Minute digits
begin to flash. Press the B or F buttons to adjust the display to the correct
minute, Example: 6:30 AM, and then press the MEMORY (PROG)/CLOCK ADJ
button again.
6. Repeatedly press the ALARM button to cycle through the alarm modes as follows:
• First Press: ALARM BUZZER
• Second Press: ALARM CD
• Third Press: ALARM TUNER
• Fourth Press: ALARM ‘Off’ (ALARM indicator disappears)
When the desired alarm mode is flashing stop pressing the ALARM button. The
Alarm indicator remains 'On' and the selected mode indicator continues to flash.
This is your indication that the alarm is set. It will turn on every day at the time
you programmed.
7. To cancel alarm operation press the ALARM button until the ALARM indicator
disappears and none of the Alarm mode indicators are flashing.
8. To stop the alarm immediately after it turns on in the morning press the STANDBY
(POWER) button. The alarm stops immediately and resets itself for the following
day.
TUNER
ALARM
TUNER
ALARM
ES2_ib041503.p65 15/4/2003, 9:36 25