Emerson Radio ES2 - Manual (Page 24)

23
FM STEREO/MONO Mode Button
(On Remote Control Only)
If FM reception is noisy or weak, and repositioning the FM wire antenna does not
provide any improvement, press the FM STEREO/MONO mode button on the remote
control change from FM Stereo to FM Mono reception mode. This will normally provide
an improvement in reception quality although the signal will no longer be in stereo.
Remember to switch back to the FM Stereo mode when you tune to other stations
with better reception.
Time Display
During Tuner operation the display shows the frequency of the station you selected.
To see the Time during Tuner operation press the REMAIN/MODE button once. The
display changes from radio frequency to current time for 9 seconds approximately ,
and then changes back to radio frequency automatically.
Note: If you continue pressing the REMAIN/MODE button the display will also show
the ALARM timer settings. See following page for additional information.
ES2_ib041503.p65 15/4/2003, 9:36 23