Epson 8000i - Manual (Page 150)

5 • Maintenance 140
4. Use a screwdriver to loosen the three screws holding the lamp unit
in place. (You cannot remove these screws.)
5. Lift up the handle and pull out the lamp unit.
6. Gently insert the new lamp unit by lowering it into position.
Make sure it’s inserted securely. Tighten the screws on the new
lamp unit.
7. Replace the lamp cover and tighten the cover screws. (Make sure
the lamp cover is securely fastened. The projector turns itself off
if the lamp cover is open.)
80009000.book Page 140 Monday, November 1, 1999 9:35 AM