Emerson Radio CKD2300 - Manual (Page 5)

4
PREPARATION FOR USE
Unpacking and Set Up
• Carefully remove the unit from the display carton. Remove all the packing material
from the unit and remove any small strips of tape that may have been used to
prevent the CD door from opening in transit.
• Unwind the AC power cord and extend it to its full length.
• Unwind the FM antenna wire and extend it to its full length.
• This unit was shipped with a dummy CD transit card in the CD player. This
dummy CD prevents the laser pick up from moving during shipment. This card
must be removed before you can insert your own CDs. Open the CD door,
remove the transit card and discard it.
• Place the unit on a flat, level surface such as a table, desk, counter, shelf, etc,
convenient to a 120V 60 Hz AC outlet, out of direct sunlight, and away from
sources of excess heat, dust, moisture, or strong magnet fields.
Battery Back Up System
This model includes a battery back up circuit that will maintain the clock and alarm
settings in the event of a temporary power interruption. The battery back up system
requires one 9-Volt battery, not included. The battery compartment is located on
the bottom of the cabinet.
1.) Press the battery door-locking tab in the direction of the arrow and remove the
battery door.
CKD2300_060305.p65 3/6/2005, 11:04 4