Emerson Radio CKD2020 - Manual

AM/FM Radio, CD-R/RW Player
with Dual Alarm Clock
OWNER'S MANUAL
CKD2020
Visit our web site at www.emersonradio.com
!
WARNING WARNING
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN
EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES
CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE
OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
The lightning flash with arrow-
h e a d s y m b o l , w i t h i n a n e q u i -
lateral triangle is intended to
alert the user to the presence
of uninsulated‘dangerousvoltage’
within the product’s enclosure
t h a t m a y b e o f s u f f i c i e n t
magnitude to constitute a risk
of electric shock to persons. WARNING:TO REDUCE THE
RISK OF ELECTRIC SHOCK
DO NOT REMOVE COVER
( O R B A C K ) , N O U S E R
SERVICEABLE PARTS INSIDE
R E F E R S E R V I C I N G T O
Q U A L I F I E D S E R V I C E
PERSONNEL. The exclamation point within
an equilateral triangle is in-
tended to alert the user to
the presence of important
operating and maintenance
(servicing) instructions in
the liter ature accompany-
ing the appliance.
The information Marking is located at the bottom enclosure of the apparatus.
IMPORTANT SAFETY INSTRUCTIONS
1.) Read these instructions. Keep these instructions. Follow all instructions. Heed all warnings.
2.) Do not use this apparatus near water.
3.) Clean only with dry cloth.
4.) Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.
5.) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
6.) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong is provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
7.) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
8.) Only use attachments / accessories specified by the manufacturer.
9.) Unplug this apparatus during lightning storms or when unused for long periods of time.
10.) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has
been damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled
or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture,
does not operate normally, or has been dropped.
11.) Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with
the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
12.) The apparatus shall not be exposed to dripping or splashing and that no
objects filled with liquids, such as vases, shall be placed on apparatus.
13.) Main plug is used as disconnect device and it should remain readily
operable during intended use. In order to disconnect the apparatus from the
mains completely, the mains plug should be disconnected from the mains
socket outlet completely.
14.) Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
15.) The marking information is located at the bottom of apparatus.
CAUTION: Danger of explosion if battery is incorrectly replaced, replace only with the same or
equivalent type.
1
Thank you for purchasing this Emerson Clock Radio.
We have taken every precaution to make sure this radio was in perfect working order
when it left our factory. If you encounter any problems with the set up or operation of
this item, please call the Emerson Consumer Products Corp., Customer Service
Hotline, toll free, at 1-800-898-9020.
IMPORTANT NOTES
• Avoid installing this unit in places
exposed to direct sunlight or close to
heat radiating appliances such as
electric heaters,on top of other stereo
equipment that radiates too much
heat,places lacking ventilation or dusty
a r e a s , p l a c e s s u b j e c t t o c o n s t a n t
vibration and/or humid or moist areas. • Operate controls and switches as
described in the manual.
• Before turning on the power, make
certain that the power cord is properly
installed.
• When moving the set, be sure to first
disconnect the AC power cord.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged, to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TVtechnician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
2
PLAYER MAINTENANCE
Cleaning the Cabinet
IMPORTANT: Disconnect from Main Supply Before
cleaning.wipe with a soft cloth. If the cabinet is very
dirty, dampen the cloth with a weak solution of neutral
detergent and water, and then wipe clean.
Cleaning the Lens
A dirty lens may cause the sound to skip and, If the
lens is very dirty, the CD may not work. Open the
disc cover and clean the lens as follow:
Dry Dust Particles
Using a camera lens brush/blower, blow on the
lens couple times, then wipe it lightly with
the brush to remove dust. Then, blow on the lens
once more.
Finger prints
If the lens cannot be cleaned by using a brush/
blower use a dry cotton swab.
Cleaning the Disc
1. To handle a disc use only one of the two
manners.
Note: Do not touch the rainbow colored side.
2. To wipe a disc, use only a soft cloth. Do not
use benzene or thinner which will damage
the disc, the disc should always be wiped
in a straight line from the centre to the edge.
It should never be wiped in a circular motion.
3. Never place the disc on other equipment or
near any heat source. Avoid positions
where the disc would be subjected to
direct sunlight for long periods.
When AC power is interrupted, both time
and alarm settings will be lost (unless
2 x AAA battery (not supplied) is installed)
after power is restored. The digital display
will blink to show power was interrupted.
You must reset time and alarm times.
To keep alarm and time of day settings in
memory during a brief power failure or
accidental removal of AC cord from mains
socket, install 2 x 1,5V “AAA” battery
( n o t s u p p l i e d ) i n t o t h e B a t t e r y
Compartment on the underside of the unit.
Corrosion, oxidation, battery-leakage
and any other gradually acidic defect of
this nature will invalidate the guarantee.
Electronic products should never be
subjected to extreme temperatures
nor high humidity to ensure good
performance and a long life-time.The
clock radio should not be placed in
bathing areas, or around stoves and
radiators, etc. Always leave sufficient
space around the unit for ventilation.
If necessary, only clean the cabinet of
the unit with a soft dampened piece of
cloth, (be sure the AC power cord is
unplugged from the outlet). Never use
a polish or a strong detergent for
cleaning since this can damage the
finish o f t he c
ab i n e t.
DISC CLEANING, POWER FAILURE
3
Maintenance and care Power failure
Battery back up
If the cabinet becomes dusty, wipe it
with a soft cloth. If the cabinet
becomes smudged or dirty, clean it
with a soft, silghtly dampened cloth.
Never allow water or any liquid to get
i nside t he c a b i n e t .
Never use any abrasive cleaners or
cleaning pads as these will damage
t he f inish of y our ra di o .
1.
2.
3.
4
5
6
7
PREPARATION FOR USE
Unpacking and Set Up
Remove the unit from the carton, and remove all the packing materials from the
unit.
Save the carton and packing materials in case the unit ever needs to be returned
for service Using the original carton and packing materials is the only way to
safely repack the unit for shipment.
Remove any descriptive labels or stickers from the top or front of the unit. Do
not remove any labels from the back or bottom of the cabinet.
Remove any small strips of tape that may have been used to prevent the CD
door from opening in transit.
Note the Serial Number on the bottom of your radio and write this number in
the space provided on the Warranty page of this manual.
Press the CD OPEN button to open the CD door and remove the dummy CD
protection card from the CD compartment. Discard it and close the CD door.
Unwind the FM wire antenna on the back cabinet and extend it to its full length.
Protect Your Furniture
This model is equipped with non-skid rubber ‘feet’ to prevent the product from moving
when you operate the controls. These ‘feet’ are made from non-migrating rubber
material specially formulated to avoid leaving any marks or stains on your furniture.
However certain types of oil based furniture polishes, wood preservatives, or cleaning
sprays may cause the rubber 'feet’ to soften, and leave marks or a rubber residue on
the furniture. To prevent any damage to your furniture we strongly recommend that you
purchase small self-adhesive felt pads, available at hardware stores and home
improvement centers everywhere, and apply these pads to the bottom of the rubber
‘feet’ before you place the product on fine wooden furniture.
Power Sources
This system is designed to operate on 120V AC 60Hz house current only. Connecting
this system to any other power source may cause damage to the system and such
damage is not covered by your warranty.
NOTE: This system has polarized AC plug with one wide blade and one narrow blade.
This plug will only fit into a matching polarized AC outlet.
This is a safety feature to reduce the possibility of electric shock. If this plug will not fit
in your AC outlet, you probably have an outdated non-polarized outlet. You should
have your outdated outlet changed by a qualified, licensed electrician.
Do not file the wide blade on the plug, or use an adapter to make the plug fit into your
outlet. This defeats the safety feature and could expose you to electric shock.
AC Outlet
AC Plug
12131415
16 17 19 20 21 18
LOCATION OF CONTROLS
1 2 3 4 5
6
7
8 9 10 11
CAUTION RI SK O F EL EC TR IC S HO CK DO N OT O PE N WAR NI NG :S HO CK H AZ AR D. DO N OT O PE N AVIS :R IS QU E DE C HO C ÉL EC TR IQ UE ,N E PAS OU VR IR
22
23
A
B
C
F D
E
G J I
24
1. CLOCK ADJ button
2. ALARM2 button
3. ALARM1 button
4. VOLUME control
5. AUX IN Jack
6. SNOOZE button
7. CD door
8. OPEN button
9. ON/OFF button
10. FUNCTION (CD/AM/FM/
BUZZER) switch
11. TUNING control
12. PROGRAM button
13. REPEAT/RANDOM button
14. DISPLAY button
15. SLEEP button
16. 0.9"CLOCK display
A.ALARM 1 indicator
B.ALARM 2 indicator
C.POWER indicator
D.SLEEP indicator
E.RANDOM indicator
F.PROGRAM indicator
G.REPEAT indicator
I.SNOOZE indicator
J.PM indicator
17. PLAY/PAUSE button
18. SKIP I<< /MINUTE button
19. SKIP >>I/HOUR button
20. STOP button
21. Speaker
22. Battery Compartment
23. AC Power Cord
24. Pigtail FM Antenna
SETTING THE CLOCK/TIME
. Connect the AC power cord to a wall outlet.
1.12:00 will show on the display and begin to flash.
2.Press >>I /HOUR button to set the hour and then press I<< / MINUTE button to set
the minute.
3.Press the CLOCK ADJ button to confirm the time, the display will stop flashing.
4.You can switch the clock display between 12H and 24H by holding the CLOCK ADJ
button for 2 seconds.
5.During OFF MODE, you can press the CLOCK ADJ button and then repeat step 2
and 3 to change the time as well.
Remarks: The clock does not keep time during a power failure unless backup
batteries are fitted (See“Power Connection”on page 4)
1.Slide the function (CD/AM/FM/BUZZER) switch to AM or FM position ,
2.Press the ON/OFF button to switch ON the unit, the power ON indicator will light up
on display.
3.Adjust the VOLUME control to the desired level.
4.Tune into a station using the TUNING control.
LISTENING TO THE RADIO
Unwind the AC power cord and extend it to its full length.
Place the unit on a stable, level surface such as a table, desk, shelf, etc within
easy reach of an AC outlet, out of direct sunlight, and away from sources of
excessive heat, dust, moisture or humidity.