Emerson Radio CKD2300 - Manual (Page 11)

10
Setting The Wake-Up Times
The procedure for setting the Alarm 1 and Alarm 2 wake up times
is the same.
1.) Slide the ALARM 1 switch, located on the left side of the
cabinet to the “SET” position.
The display changes from the correct time to
the Alarm 1 wake-up time. The first time you
set the Alarm 1 or Alarm 2 wake-up time the
display will flash “12:00” (AM).
2.) Press the SKIP/ SEARCH / HOUR button to set the display to the desired
Alarm 1 wake-up hour, AM or PM. If the PM indicator is ‘Off’ the wake-up hour
displayed is AM.
3.) Press the SKIP/SEARCH / MIN. button to adjust the display to the desired
Alarm 1 wake-up minute.
4.) Slide the ALARM 1 switch back to the “OFF” position. The display changes
from the Alarm 1 wake-up time back to the correct time.
5.) Follow the same procedure to set the Alarm 2 wake-up time if desired.
To check the wake-up times just slide the ALARM 1 or ALARM 2 button to the
“SET” position at any time. Slide the switches back to the “OFF” position to return
to the correct time.
Note: If both of the Alarm switches are set to “SET” at the same time the clock
will display the correct current time, not the Alarm 1 or Alarm 2 wake up time.
So be sure to set the ALARM 1 switch back to the “ON” or “OFF” position
before setting the ALARM 2 switch to the “SET” position.
PM
AL 1 AL 2
ALARM 1
CKD2300_060305.p65 3/6/2005, 11:04 10