Extreme Networks Px Series - Manual (Page 37)

Px Series Application Switch Installation and Configuration Guide 4-7
Managing the PxM
Managing the PxM
You can manage the PxM in any of the following ways:
• Using the connect command in the BlackDiamond.
• Using the serial port (useful for debugging).
• Using the 101100 port (for out-of-band management).
VLANs are always enabled on the PxM. A configuration that does not contain VLAN
information will fail to build and report syntax errors for the PxM. You must configure
a VLAN on the MSM before you configure it on the PxM. See “Configuring VLANs” on
page 4-8.
Table 4-3 shows BlackDiamond ExtremeWare commands that apply solely to the PxM,
or have specific syntax that applies to the PxM:
Table 4-3: Commands Unique to the PxM
Command Description
connect slot Creates a PxM session for the specified
slot.
show pxm [interfaces] [slot ] Displays data on the PxM in the specified
slot. If no slot is specified, displays data on
all PxMs in the chassis. If you specify the
optional
interfaces argument, the
command updates the statistical
information in real time.
download [image|config]
[primary|secondary]
[slot ]
Downloads the specified image or
configuration from the specified host to the
PxM in the specified slot. If no slot is
specified, downloads to all PxMs in the
chassis.
use [image|config] [primary|secondary]
[slot ]
Sets the default image or configuration for
the PxM in the specified slot. If no slot is
specified, sets the default for all PxMs in
the chassis.