Extreme Networks Px Series - Manual (Page 26)

2-8 Px Series Application Switch Installation and Configuration Guide
Writing data to Flash
Done
4 When you are finished using the facility, log out of the application switch.
You can now access the Gigabit Ethernet port directly via Telnet.
Configuring the 10/100 Ethernet Management Port
The 10/100BT Ethernet management port provides dedicated remote access to the
application switch using TCP/IP. It supports Telnet using the command-line interface.
The 10/100BT port is designed to be used as an out-of-band management port only. It does
not function as a load balancing port.
To use the management interface, you must assign it an IP address and subnetwork
mask, using the following command:
config mgmt ip /
The 10/100BT port has a separate routing table. By default, no routes are installed in the
routing table. You must explicitly configure routes. After the IP address has been
configured, install a route for the network, using the following command:
config mgmt iproute dest-ip gateway
You can add additional routes, as needed.
The configuration of management port information is executed immediately. You
do not need to use the
build command.
The following example configures an IP address and installs two network routes:
station1:4 # config mgmt ipaddress 10.10.10.2 / 24
station1:5 # config mgmt iproute dest-ip 10.10.10.0 gateway 10.10.10.1
station1:6 # config mgmt iproute dest-ip 10.10.11.0 gateway 10.10.10.1