Electrolux U31175 LU4 9QQ - Manual (Page 11)

8 operating conditions/energy tips/inclusions electrolux EXP09CS1WI 8 installation and removal of exhaust hose electrolux EXP09CS1WI
The exhaust hose must be installed or removed in
accordance with the usage mode indicated in the
table below
Mode Exhaust hose
Cool, fan, ventilation Install
Dehumidification Remove
Installation of the exhaust hose
1. Attach the window exhaust adapter to the exhaust hose
• Extend one end of the exhaust hose and insert it into
the window exhaust adapter, and turn it (approx. three
times) until it stops.
• Make sure they are securely attached.
. Attach the exhaust hose couple to the unit
• Insert the two projections on the exhaust hose couple
into the two holes on the unit, and firmly attach them
to each other.
3. Slide and open the exhaust cover on the window panel,
and attach the window exhaust adapter
• Surface of window exhaust adapter marked
“TOP” should be at the top when it is installed in a
doublehung sash window.
• Surface of window exhaust adapter marked “TOP”
should be on the window frame side when it is
installed in a sliding sash window.
Installation and removal of exhaust hose
Installation only together with “window kit”
The exhaust hose should be as short as possible for opera-
tional efficiency; however, it must not be twisted or bent.
Unacceptable
Acceptable
Acceptable
Removal of the exhaust hose
1. Remove the window exhaust adapter.
• Pull out and remove the window exhaust adapter by
pushing down the two “PUSH” markings, and slide
and close the exhaust cover in the window panel.
. Remove the exhaust hose couple from the unit.
• Lift up and remove the exhaust hose couple from the
unit by pushing down on the two projections.
Window
exhaust
adapter
Extend
Exhaust hose
Exhaust hose
couple
Projection
Hole
“TOP”
“PUSH”
Exhaust hose couple
Projection