Equator WB 65 - Manual (Page 21)

Installation Instructions
Placement of the Dishwasher in the Cabinet
Opening
• After following all previous instructions
regarding both cabinet and dishwasher
preparation, the machine can now be carefully
slid into the cabinet opening.
• Place dishwasher in front of the opening.
• Route power cord, drain line and routing hose
through the necessary cut-outs in the cabinet
opening.
• Carefully move the dishwasher into the cabinet
opening while pulling the connection lines
(power, drain & water) through the cut-outs of
the cabinet side panel.
• Position the dishwasher such that it is properly
centered in the opening and in correct
alignment with the adjacent cabinet facias.
• Once properly positioned, secure the
dishwasher to the underside of the countertop
with wood screws through the flange holes
located at the top front of the dishwasher.
Important: To ensure proper door sealing and
operation the following conditions must be met:
1.The machine is properly
leveled (front-to-rear and side-
to-side).
2.The door panel is plumb to the
cabinet facia.
Adjustable Width Strips
Optional adjustable width strips (2) are provided
with each dishwasher for mounting to the front of
the stainless steel dishwasher tank. The strips
are intended to extending the overall width of the
dishwasher over exposed areas that may exist if
the cabinet cut-out width is excessive.
With the screws provided, attach the width strips
to the front vertical edges of the dishwasher tank
as illustrated. Adjust the strips to minimize or
eliminate exposed area.
21
Right
Side
Trim
Screws
Left
Side
Trim