Equator WB 65 - Manual (Page 19)

Installation Instructions
19
Electrical Connection
• The dishwasher requires a dedicated grounded
electrical supply rated at 120 VAC, 15 amps,
60Hz.
• The dishwasher is pre-fitted with a flexible power
supply cord with a three-prong, grounding-type
plug to connect to a grounded outlet.
• The power-supply receptacle for the dishwasher
must be installed in a cabinet or on a wall
adjacent to the undercounter space in which the
appliance is to be installed.
• Provide an opening, not to exceed a maximum 1-
1/2" (38 mm) diameter, through the cabinet
partition for the attachment plug and cord to
pass through.
• Suitably treat the edges of the specified opening
as follows:
• Wood cabinet: Edges must be smooth and
rounded.
• Metal cabinet: Order special grommet, the
Service Center.
• Take care when installing or removing the
dishwasher to avoid possible damage to the
power-supply cord.
Water Connection
• The dishwasher is pre-fitted with a direction-
adjustable high-pressure water supply hose that
has 3/4" NPT internal pipe threads.
• For your convenience, supplied with the
dishwasher is a 3/8" comp. x 3/4" NPT brass
fitting that adapts the hose connector to a stan-
dard 3/8" compression fitting common to most
household dishwasher water supply shut-off
valves. As an alternative the hose can be
connected directly to a locally sourced 3/4" NPT
male brass connector available in most hardware
stores.
• Adjust the direction of the hose and its
connection as it exits the rear of the machine
based on the installation requirements.
Important: Ensure the hose connector on the rear of
the dishwasher is fully tightened before installing.
OR
Shut - off Valve
Washer
3/8" Comp. x 3/4" BSP
Shut - off Valve 3/4" NPT
Water Supply Hose
Water Supply Hose