beautypg.com

LG 30 Inch Electric Slide-In Smart Range Owner Manual User Manual

Page 57

background image

57

MAINTENANCE

EN
G

LI

SH

cookware, aluminum foil or any other material

from the oven.
- If oven racks are left in the oven cavity during

the Self Clean cycle, they will discolor and

become difficult to slide in and out.

• The kitchen should be well ventilated to

minimize the odors from cleaning. Open a

window or turn on a ventilation fan or hood

before self-cleaning.

• Wipe any heavy spillovers on the bottom of the

oven.

• Make sure that the oven light lamp cover is in

place and the oven light is off.

• Clean the frame of the oven and door with hot

soapy water. Rinse well.

WARNING

• If the oven is heavily soiled with oil, self-clean the

oven before using the oven again. The oil could

cause a fire.

• If there is a fire in the oven during self-clean,

turn the oven off and wait for the fire to go out.

Do not force the door open. Introduction of

fresh air at self-clean temperatures may lead to

a burst of flame from the oven. Failure to follow

this instruction may result in severe burns.

CAUTION

• Do not use oven cleaners. Commercial oven

cleaner or oven liner protective coating of any

kind should not be used in or around any part of

the oven.

• The oven displays an F error code and sounds

three long beeps during the self-cleaning

process if it malfunctions in the self-clean mode.

Switch off the electrical power to the main fuse

or breaker and have the oven serviced by a

qualified technician.

• If the self cleaning mode malfunctions, turn the

range off and disconnect the power supply. Have

it serviced by a qualified technician.

• It is normal for parts of the oven to become hot

during a Self Clean cycle. Avoid touching the

cooktop, door, window or oven vent area during

a Self Clean cycle.

• Do not leave small children unattended near the

appliance. During the Self Clean cycle, the

outside of the range can become very hot to the

touch.

• If you have pet birds, move them to another

well-ventilated room. The health of some birds is

extremely sensitive to the fumes given off during

the Self Clean cycle of any range.

• Do not line the oven walls, racks, bottom or any

other part of the range with aluminum foil or

any other material. Doing so will destroy heat

distribution, produce poor baking results and

cause permanent damage to the oven interior

(aluminum foil will melt to the interior surface of

the oven).

• Do not force the door open. This can damage the

automatic door locking system. Use care when

opening the oven door after the Self Clean cycle.

Stand to the side of the oven when opening the

door to allow hot air or steam to escape. The

oven may still be VERY HOT.

NOTE

• The oven light cannot be turned on during a Self

Clean cycle. The oven light cannot be turned on

until the oven temperature has cooled below

500

˚

F (260

˚

C) after a Self Clean cycle is

complete.

• During the Self Clean cycle, the cooktop

elements and warming drawer cannot be used.

• Clean the frame of the oven and door with hot

soapy water. Rinse well.

• Do not clean the gasket. The fiberglass material

of the oven door gasket cannot withstand

abrasion. It is essential for the gasket to remain

intact. If you notice it becoming worn or frayed,

replace it.

• It is normal for the fan to operate during the Self

Clean cycle.

• As the oven heats, you may hear sounds of metal

parts expanding and contracting. This is normal

and will not damage the oven.

• You may notice some white ash in the oven.

Wipe it off with a damp cloth or a soap-filled

steel wool pad after the oven cools. If the oven is

not clean after one Self Clean cycle, repeat the

cycle.

• If oven racks were left in the oven and do not

slide smoothly after a Self Clean cycle, wipe racks

and rack supports with a small amount of

vegetable oil to make them glide more easily.

• After a Self Clean cycle, fine lines may appear in

the porcelain because it went through heating

and cooling. This is normal and will not affect

performance.

• The Self Clean cycle cannot be started if the

Control Lock feature is active.

• Once the Self Clean cycle is set, the oven door

locks automatically. You will not be able to open

the oven door until the oven is cooled. The lock

releases automatically.

us_main.book.book Page 57 Thursday, June 17, 2021 8:05 AM