LG 30 Inch Electric Slide-In Smart Range Owner Manual - Manual (Page 27)

27 OPERATION
EN
G
LI
SH
Setting Convection Auto Conversion
(Model LSEL6333*)
When Conv. Bake and Conv. Roast are selected,
Convection Auto Conversion automatically
converts the standard recipe temperature entered
to a convection temperature by subtracting 25 °F /
14 °C. This auto converted temperature shows on
the display. For example, select Conv. Bake , enter
350 °F, and 325 °F shows on the display after
preheat.
Convection Auto Conversion is enabled by default.
To change the setting, follow these instructions.
1
Set the oven mode knob to the Off position.
2
Press and hold Start Time for 3 seconds.
Then press the Start Time key repeatedly
until Auto appears in the display.
3
Press plus(+) or minus(-) to enable or disable
the feature.
4
Press START to accept the change.
Adjusting the Oven Thermostat
Your new oven may cook differently from the one
it replaced. Use your new oven for a few weeks to
become more familiar with it before changing the
temperature settings. If after familiarizing yourself
with the new oven, you still think that it is too hot
or too cold, you can adjust the oven thermostat
yourself.
• To begin, either raise or lower the thermostat 15
°F (8 °C). Try the oven with the new setting. If the
oven still needs adjustment, raise or lower the
thermostat again, using the first adjustment as a
gauge. For example, if the adjustment was too
much, raise or lower the thermostat 10 °F (5 °C).
If the adjustment was not enough, raise or lower
the thermostat 20 °F (12 °C). Proceed in this way
until the oven is adjusted to your satisfaction.
Model LSEL6333*
1
Set the oven mode knob to the Off position.
Press and hold Start Time for 3 seconds.
Then press Start Time repeatedly until AdJU
appears in the display.
2
Set the number of degrees to adjust:
Press or press and hold the +/- buttons until
the desired number of degrees appears in the
display.
3
Press START to accept the change.
Model LSEL6331*
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until AdJU appears in
the display.
2
Set the number of degrees to adjust:
Press or press and hold the +/- buttons until
the desired number of degrees appears in the
display.
3
Press START to accept the change.
NOTE
• This adjustment does not affect the broiling or
Self Clean temperatures. The adjustment is
retained in memory after a power failure. The
oven temperature can be increased (+) or
decreased (-) as much as 35 °F or 19 °C.
• Once the temperature is increased or decreased,
the display shows the adjusted temperature
until it readjusts.
Turning the Preheat Alarm Light On/Off
When the oven reaches its set-temperature, the
preheating alarm light flashes 5 times or until the
oven door is opened.
You can activate or deactivate the preheating
alarm light.
Model LSEL6333*
1
Set the oven mode knob to the Off position.
Press and hold Start Time for 3 seconds.
Then press Start Time repeatedly until PrE
appears in the display.
2
Press +/- to turn the light on/off.
3
Press START to accept the change.
Model LSEL6331*
1
Press and hold Clock for 3 seconds. Then
press Clock repeatedly until PrE appears in
the display.
2
Press +/- to turn the light on/off.
3
Press START to accept the change.
Adjusting the Beeper Volume
Model LSEL6333*
us_main.book.book Page 27 Thursday, June 17, 2021 8:05 AM