Verifying proper operation, Installation instructions – Dacor Contemporary 36 Inch Freestanding Professional Gas Smart Range Installation Manual User Manual
Page 48
English
48
Installation instructions
Installation instructions
Verifying proper operation
Before operating the range, read the accompanying use and care manual completely. It
contains Important safety, service and warranty information.
1.
Before beginning the test procedure, ensure that all cooktop control valves are in the
OFF position, and all burner rings, burner caps, and grates are properly positioned on
the cooktop frame.
2.
Turn on the gas supply at the shut-off valve. Check for gas leaks.
3.
Turn on power to the range at the circuit breaker or fuse box.
4.
Follow the prompts on the oven’s display to set up the user preferences and wireless
network settings.
5.
Touch the MENU key on the display.
6.
Touch the BAKE key on the display. The default bake temperature should appear on
the display .
7.
Touch Start. After 3 minutes, open the door to make sure the air inside the oven has
begun to heat.
8.
The display should show BAKE, and the preheating temperature.
9.
Touch
OFF
to stop oven heating process.
10.
Test one of the burners by pushing the knob in and turning it counterclockwise to
the HIGH position. It may take up to four seconds for ignition to occur, at which time
the ignitor will stop sparking. If ignition does not occur within four seconds, turn off
the knob, wait for at least five minutes to allow any gas to dissipate, then repeat the
ignition test. After ignition, rotate the control knob counterclockwise from HIGH to
LOW to adjust the flame height progressively. When the burners are installed correctly
and gas flows properly, the flame will be steady and quiet. It will also have a sharp,
blue inner cone that will vary in length proportional to the burner size.
11.
Turn the control knob to the OFF position.
12.
Repeat the ignition test for all remaining burners.
13.
Yellow tips on outer cones—Normal for LP gas operation.
Normal Flame
Install_NX9900R_PRORANGE_DOP36M96_DA_DG68-01106C-02_EN+MES+CFR.indb 48
2019-08-13 6:30:56