Before you begin, Important, Electrical requirements – GE 8,050 BTU Smart Window Air Conditioner Installation Instructions User Manual
Page 9: Tools you will need

49-5000433
9
INST
ALLA
TION INSTRUCTIONS
Installation Instructions
Questions? Call GE Appliances at 866.907.1655 or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully.
•
IMPORTANT
—
Save these instructions for
local inspector’s use.
•
IMPORTANT
—
Observe all governing codes
and
ordinances.
•
Note to Installer
– Be sure to leave these
instructions with the Consumer.
•
Note to Consumer –
Keep these instructions for
future reference.
•
Skill level –
Installation of this appliance requires
basic mechanical skills.
•
Completion time –
Approximately 1 hour
• We recommend that two people install this product.
• Proper installation is the responsibility of the
installer.
• Product failure due to improper installation is not
covered under the Warranty.
installation procedures as described in these ELECTRICAL REQUIREMENTS 7KHVHPRGHOVUHTXLUHDYROW$& 60-Hz grounded outlet protected with a The 3-prong grounding plug minimizes the possibility TOOLS YOU WILL NEED CAUTION Do not, under any circumstances, cut or remove the Power cord includes a current interrupter device. A Phillips head screwdriver Ruler or tape measure Pencil Level Scissors or knife Flat-blade screwdriver
instructions when installing this air conditioner.
15-amp time-delay fuse or circuit breaker.
of electric shock hazard. If the wall outlet you plan to
use is only a 2-prong outlet, it is your responsibility
to have it replaced with a properly grounded 3-prong
wall outlet.
third (ground) prong from the power cord.
Do not change the plug on the power cord of this air
conditioner.
Aluminum house wiring may present special
problems—consult a qualified electrician.
test and reset button is provided on the plug case. The
device should be tested on a periodic basis by first
pressing the TEST button and then the RESET button
while plugged into the outlet. If the TEST button does
not trip or if the RESET button will not stay engaged,
discontinue use of the air conditioner and contact a
qualified service technician.